I should preface this by saying that it’s not completed yet, but I’ve mostly installed the new stereo head unit in my 1991 Mitsubishi Delica Chamonix. This whole thing turned into a bit of a wiring nightmare which is why it took me so darn long to finish up. Well, that and the fact that I decided to wait for installation of several elements until I get an intact windshield back in the van.
What Was I Dealing With?
So the van came from Japan with a karaoke machine and a TV installed. All of these electronics were vintage 1990’s junk that could only work in Japan (Japanese radio and TV stations transmit within a sperate frequency set) and I’m pretty certain that most of it was in questionable condition regardless. Consequently, my first task was to rip all that junk out of the dash. And, well pretty much the rest of the van too (the TV was wired to the back as well the microphone for the karaoke machine and a bunch of tuner equipment).
I pulled most of this wiring in about a day of diligently unscrewing headliner and lifting carpets. There are still a couple of things I’m going to need to return to once all this is complete. Primarily, the diesel-timer (a common device used for slowly cooling diesel engine after you cut the ignition) and a bunch of early 90’s lighting, but the entertainment harness, all the way to the fuse box, has been cleaned and uninsulated wire (of which there was much) has been replaced.
next came manual mapping of the harness. This took me a good long time and then was complicated by the fact that I reverse the order of the wiring on the stereo side. Oops! Eventually, I ended up double checking my map and then writing the pinouts on both sides of the harness with a permanent marker. My flawed wiring was immediately obvious then so when I rewired the stereo side everything began working.
What’s Left to Do?
The backup camera and the dash cam, on hard-wired power, need to be installed. Also, I’ve purchased a USB harness that will fit flush in the dash. That’s going to take some cutting to get it in there right, but shouldn’t be that difficult.
As soon as I get the van back I’m going to replace all the interior lighting with LED equivalents. I’ll need to completely take apart the dash this time to make this happen, but since most of the existing bulb died back in 1997, it’s a project long overdue.
I *may* spin up a second project from this to reprint the speedo template with KPH and MPH (right now it’s all metric). Given that I’ve gotten pretty good and doing the conversion math in my head it’s not necessary, but I also think I’d prefer a white background on the dash instead of the stock black.
Right now the van is with the auto body shop. Once they’re finished fixing the paint, roof, and windshield I’ll complete the electronics package installation.